Mixing Tube For Abrasive Waterjet Machine
Abrasive Waterjet Nozzles are also called mixing tubes or focusing tubes which are mainly installed in waterjet cutting machine and they can cut materials such as metal, ceramic, stone, glass, and other materials. They are especially wear-resistant. In particular, when compressing water to 42,000 Psi and shoot it out of the nozzles, the water can cut inch-thick metal easily by using the aforementioned 42,000 Psi water jet laced with garnet abrasive.
In addition to the great performance of wear resistance, We want to ensure you have the right solution for the best cost-effectiveness, too. So we have developed 4 innovative product lines of Abrasive Waterjet Nozzles. Besides, our mixing tubes are suitable for all modern cutting head systems, therefore they can definitely help you to cut out the way of success.
- Whether the inner diameter of the orifice and the inner diameter of the mixing tube is 1: 3, for example, the inner diameter of the mixing tube is 1.02mm, and the inner diameter of the orifice should be 0.3mm. In this way, the wear from the wall is minimal.
- The size and quality of the garnet. Excessive and impure waterjet garnet will accelerate the wear of the waterjet nozzles.
- Dirty, hard, and insufficiently filtered water can easily destroy the nozzles under ultra-high pressure, and the emitted water can scatter and quickly damage the inner wall of the mixing tube.
- The main influencing factor is the concentricity of the orifice and the mixing tube. Even if there is only a very small deviation of the concentricity, it will also cause the tilt of the water column, which directly impacts on one side of the inner wall of the mixing tube, thus quickly wears out the tube and at the same time will cause weak cutting and slow down the cutting speed.
Only logged in customers who have purchased this product may leave a review.